Tormach PSG 612, Руководство оператора

Страница: 15 / 36

ADJUSTING TABLE FLAGS
Adjust the distance between the X-axis and Y-axis table
flags to the size of the part being ground.
To set the X-axis and Y-axis travel limits, move the table
flags to the desired location by loosening and sliding the
thumbscrews.
Note: Different table speeds will produce different
amounts of overtravel. As an example, with slow
table movement the table will stop quicker in a
smaller distance than when the table speed is faster.
You may need to adjust the table flags if you change
your table speed.
note: The thumbscrews must remain on opposite
sides of the proximity switch located in the center
of the grinding surface under the table guard. If
both screws (table flags) are moved to either side
of the proximity switch, the table will not run. If the
proximity switch is defective, the LEDs will not light.
Keep the travel flags on opposite sides of the
proximity switch located under the table guard.
INSTALLING A GRINDING WHEEL
CAUTIOn: nEVER InSTAll A
GRInDInG WHEEl THAT HAS nOT
BEEn PROPERlY BAlAnCED.
There are many reasons for changing the grinding wheel.
These include changing the type of material that is being
ground or changing the grit type of the wheel itself (for
example, from fine to course). Over time the grinding
wheel will experience wear and will need to be replaced.
1.
Remove the three socket head cap screws that hold
the wheel guard cover.
2.
Set the wheel guard cover to the side.
3. Using the spanner wrench, remove the spindle nut.
Note: The spindle nut is a left-hand thread.
WORKING WITH WHEELS
UM10159_PSG612_OPERATORS_MAnUAl_0718A
12 13
UM10159_PSG612_OPERATORS_MAnUAl_0718A