Installing the Coolant System
32352 Rev 1
10
Tormach® PCNC 1100 Deluxe Stand
7
Installing the Coolant System
Insert the flexible metal coolant tube (1)
through the hole in the base as shown in Figure
18. Next connect the coolant tube end you
inserted through the base to the coolant pump
mounted on the top of the coolant tank (3) as
shown in Figure 19 . Use Teflon tape on the
connection.
NOTE: The pump is shipped with
wiring configured for 110 VAC.
The coolant pump is dual voltage
(110VAC/220VAC ). If the pump is to be used
with 220 VAC unscrew the pump electrical cover
plate and re-wire the pump per the diagram on
the inside of the lid.
Next, referring to Figure 20 connect the Plastic
Coolant Tube(6) to the Connecting Tube (4);
Place the Connecting Tube (4) into the Support
(5); Fasten the Nut on the Flexible Tube (1) to
the the Connecting Tube (4); Use the Cap
Screws (8) to fix the Support (5) to the Mill Head
(9). Finally tighten the Screw (7)to fix the
Connecting Tube (4). The completed assembly is
shown in Figure 21.
Figure 19. Coolant tube to pump
connection.
Figure 20. Coolant tube to mill connections.
Figure 21. Completed coolant tube assembly.
