Step 5:
With all three parts properly aligned, tighten the four
1/2”
hex nuts
securing the
side plates
to the vehicle frame.
Remove the
battery tray
from the keyhole slots once the
side plates are secure. This can be done by removing the
clamp or loosening the two
3/8” nylock hex nuts
used in
step four.
Torque the four 1/2” hex nuts to 55 ft-lbs.
At this point, the installation should look like photo 2.1 on
the previous page.
Step 6:
Place the supplied
Battery Box
on top of the
Battery Tray
and slide it all the way to the side that has the four holes in
the bottom, leaving approximately 3/8” between the
battery box and the bent up flange on the tray. Mark and
drill four holes in your Battery Box that line up with the
Battery Tray. Install one
¼”-20 x 1” Hex Bolt
with one
¼” x
1- ¼”Fender Washer
through each of the four holes from
the inside of the box outward through the
battery tray.
Secure them with one
¼” Flat Washer, ¼” Lock washer
and ¼” Hex Nut
. Tighten each hex nut until the lock
washer is pressed flat, and then one additional quarter
turn. Refer to figure 6.1 on the next page for the correct
Battery Box
mounting.
