Washroom Dispenser Service and Parts Manual
Tork Matic Hand Towel Roll Dispenser, H1 System, Elevation Design
5510202; 5510282
Revision Date: 3-13-18
6
of
16
Essity Internal
Replacing the Protection Roll: 205513 (White); 205514 (Black)
1
2
1. Bend out the fitting hole on the left side.
2. Take out the protection roll (without damaging the elastic ring).
3. The new protection roll is put into position by doing the steps 1 and 2 above in reverse order.
Make sure the fitting pins are securely placed in the holes on both sides. Pull elastic ring away
from protection roll and ensure the roll turns freely.
Replacing the Cover: 225518A (White); 225519A (Black)
Phillips Head Screw
Nylon Bushing
1. Open cover. Locate Phillips head screw on both sides (inside) of cover.
2. Using Phillips head screw driver, remove screw on both sides of cover. This will allow the round,
white nylon bushing to be removed.
3. Pull one side of the cover away from the console of the dispenser. Pull the other side. Be sure to
retain the nylon bushing and screw.
4. Place new cover on the console, inserting one side then the other into the console.
5. Place bushing inside console and secure using Phillips head screw.