Checks and repairs on electrical components
42
Replacing the capacitor
To replace the capacitor, proceed as follows:
Move the unit into the repair position for the electric control, see from
page 24.
Disconnect the black cables from the connections (X1).
Flip the orange actuating lever of the capacitor on the PE terminal (PE)
upwards.
Remove the green-yellow wire of the capacitor from the PE terminal.
Release the four nuts (A) with an open-end wrench WAF 4.
Use the four nuts and an open-end wrench WAF 4 to install a functioning
capacitor.
Only tighten the nuts by hand, do not overtighten.
Connect the black cables to the connections (X1) according to the terminal
diagram.
Clip the green-yellow wire of the capacitor into the PE terminal.
Flip the orange actuating lever on the PE terminal downwards.
Mount the cover of the electric control.
