©2020 TopXGun (Nanjing) Robotic Ltd,.Co Copyright owner
20
Figure 1-2-3 charger power cable connect
Step 2: Connect the battery: Please connect the charger wiring to the battery charging port
according to the connection mode shown in the figure below.See Figure 1-2-4.
Figure 1-2-4 battery connect
Step 3. After making sure that all wires are connected correctly, press the "Start/stop" button in
the operation panel, and the charger will start self-check.The indicator light in the corresponding
channel of battery insertion is always on yellow light, and the alarm indicator is off when the
self-test is normal. If the self-test is abnormal, please refer to the description section of the
indicator state.
Step 4. Selection of working mode: After the charger self-test is completed, the charger defaults
to fast charging mode. You can select fast charging mode or slow charging mode by pressing the
button.
Step 5. Press the "Start/Stop" button in the operation panel to shut down the battery after
charging, unplug the AC power cord, and unplug the battery.
Charge
mode
Battery state
Channel indicator
state
Plug or unplug battery intruction
Fast
charge
Full battery
Channel light green
always on
Unplug battery directly
Battery wait
charging
Channel yellow
green always on
Unplug battery directly
During charging
Green flash
If plugging and unplugging is
needed, please press the start
and stop button before plugging
and unplugging. direct plugging
and unplugging are prohibited if
not press stop button
