Topwisdom TL-410, Руководство пользователя

Страница: 80 / 95

泰智科技
Shenzhen Topwisdom Technology Co., Ltd
74
1
0
L
aser Set
2. P W M F r e q u e n c y ( H Z )
1. L a s e r T y p e
3. L a s e r M i n ( % )
4 a x . L a s e r M ( % )
5. P W M D I R
6. F
ocus Length(mm)
ESC Save
1 0 0
2 0 0 0 0
2014 03 10 11 00
- - :
C O 2
P o s i t i v e
Fig. 5-15
Press the
―Up/Down‖ key to select the needed operation. Press the ―Choose‖ key to
change setting,
―Number‖ keys to set the value.

Laser Type: The common laser (CO2 glass tube), RF, and the RF (Tickle). RF is
for RF laser without pre-ignition. RF (Tickle) is for RF laser with pre-ignition that will
output 1us tickle pulse.

PWM Frequency (HZ): Press the
―Number‖ keys to change the PWM.

Laser Min/Max (%) : Range: 0
≦
the min duty ratio
≦
the max duty ratio
≦
100.

PWM DIR: P
ress ―Choose‖ to change the PWM DIR. If you found when you set
power bigger, the intensity of laser beam is stronger. Then you should change the
PWM DIR.

Focus Length (mm): Press the
―Number‖ keys to change the focus length. When
this parameter is set. Press
―.‖ Dot key in standby interface, a message box will be
shown that if reset focus length. If press
―Enter‖, the laser head will go down
controlled by U Axis. When sensors close to the material surface, reach the
designated position, a signal is given to controller, then it controls the laser head
move up to the focus position.
Attention: if laser type is RF or RF(Tickle), set the PWM Frequency to 5000, Laser
Max to 95%, not to 100%, otherwise the laser would always be on or off.
5.4.2 Equipment Set
In the Integrate interface choose
―Equipment‖ to enter, show as: