Toptica FemtoFiber pro IR, Руководство пользователя

Страница: 40 / 108

FemtoFiber
®
pro Laser System
Page 36
Status: 6.9.18
3.2 Installation Instructions FemtoFiber
®
pro Laser Head
Figure 29 FemtoFiber
®
pro laser head (example)
When installing the FemtoFiber
®
pro Laser Head the following instructions have to be observed:
• The FemtoFiber
®
pro Laser Head must be fixed by brackets or clamping forks to a breadboard
either at the protective housing or at the 3 posts (for main dimensions of the FemtoFiber
®
pro Laser
Head please see sections 6.12, 6.13 and 6.14, for mounting options please see sections 6.15 and
6.16).
• The FemtoFiber
®
pro Laser Head should only be installed in place free from vibrations.
• The FemtoFiber
®
pro Laser System is designed for indoor usage, at altitudes below 2000 m.
• Environmental conditions:
Operation temperature: +20 °C .. +30 °C, rel. humidity non condensing.
Transport/storage temperature: 0 °C .. +40 °C, rel. humidity non condensing.
• Weights: Control Unit < 4.5 kg, FemtoFiber
®
pro laser head < 15 kg depending on system variant
and options.
• Never use the FemtoFiber
®
pro Laser System near water, for example near a wash basin, a sink or
other damp environment.
• The laser beam emits through up to one of the 2 apertures shown in Figure 29 depending on the
system variant. For location of the laser beam apertures please see section 6.12.
• Only use cables supplied by T OPTICA for connection between FemtoFiber
®
pro Laser Head and
Control Unit. Use of other cables voids warranty.
NOTE ! When not in use the Oscillator Monitor Output connector must be 50
Ω
terminated by the
supplied terminator.