Humidity Setting
Daily Cleaning & Maintenance
Water Tank Cleaning
CLEANING AND MAINTENANCE
Low Water Protection
Your Toppin humidifier has a sensor to detect changes to humidity
and temperature in the surrounding area. The humidity level control
function thus can keep the humidity level as you set via the sensing
technology.
When the humidifier is on, the current humidity level will be
detected by the sensor and shown in percentage (relative humidity
level, depending on the ambient air temperature) on the LED
display.
For daily cleaning and maintenance of the exterior of the humidifier,
use a soft, damp cloth to wipe clean in case of dust or stains.
Follow the steps to clean all detachable parts and the water tank:
When the humidifier is powered on, tap the
Humidity button to enter humidity setting. The
current humidity number will turn blinking,
waiting for desired humidity setting. Tap the
button again to increase humidity to the level of
the smallest multiple of 5 (for example, when
the current humidity level is 51%-54%, tap to
increase to 55%); each tap brings an increment
of 5%, until to the maximum level of 85% (tap
again to cycle from 30%).
After the humidity is set, the current humidity
percentage will be shown again. Tap the
Humidity button once to check the last desired
humidity; tap the button again to increase the
humidity by 5% increment as described in the
last step.
To cancel the humidity setting, tap and hold the
Humidity button for 2s. The humidity number will
turn to a dash, blinking 3 times (once every 1s),
and the current humidity percentage will be
shown again.
Note:
When you’re setting the timer, the humidity level number will dim; 2s after
setting is completed, the device will exit the timer setting mode and the
humidity level will show again.
Tap and hold the Timer button for 2s to exit timer setting.
When it’s powered on, you need to set the timer again if needed (last
setting not memorized).
Low water level in water tank
When a low water level is detected in the water tank, the humidifier will be
off (fan off 20s later). 3 beeps will be heard (once every 3s) and the Low
Water icon flashes 7s. It is designed for safety concern to prevent the
humidifier from possibly overheating and damaging the nebulizer.
Low water level in mist chamber
When a low water level is detected in the mist chamber, the nebulizer will
be off (pump and fan still work). 10s later if there’s still no water
detected in the chamber, the humidifier will be off (similar process with
the “low water level in water tank” situation).
Dry run of nebulizer
When a dry run of the nebulizer is detected, the humidifier will be off
(similar process with the “low water level in water tank” situation).
Turn off the humidifier, unplug
from the wall outlet.
Leave it still for 15-20mins.
Empty the tank. Add water to
tank and clean thoroughly.
Repeat a few times until the
smell of white vinegar or other
agents becomes unobservable.
Wipe clean the interior with a
soft clean cloth especially the
nebulizer. And dry thoroughly
with a soft cloth.
Remove the tank cover, mist cover
and mist chamber section.
Fill the tank with water, add one
teaspoon of white vinegar or
other cleaning agents to remove
possible build-up.
1
2
3
4
5
6
85%
MAX
MIN
+5%
30%
Each tap
Hold for
2s
Page.9
Page.10
