Topp Music Gear TPM4200FX MKII V2, Руководство пользователя

Страница: 7 / 10

This LED lights up when the input signal is too strong. In case of the
digital effect module being muted, this LED also lights up.
17- CLIP/MUTE LED
19
20
22
18
21
FOOT SW
FX SEND
FX RETURN
MAIN OUT MONITOR
OUT
This jack is used to send out the signal from AUX bus.
19- FX SEND
This jack is used to return the sound of an effect unit to the main mix. You can also use it as an extra
auxiliary input.
20- FX RETURN
This jack is used to connect the input of an external monitor amplifier or active monitor speaker.
22- MONITOR OUTPUT
This jack is used to output the main mixsignal to an external unit.
21- MAIN OUTPUT
You can connect an external footswitch to turn the onboard effect
module on or off, via the 1/4" phone jack.
18- FOOTSWITCH
OUTPUT POWER: 2 100WATTS
MINIMUM SPEAKER LOAD: 2 OHMS
MADE IN P.R.C.
OUTPUT AC INPUT
ON
OFF
POWER
SERIAL
MODEL
TAPE OUT
LEVEL LEVEL
TAPE IN
FUSE
RATED POWER CONSUMPTION: 350W
110 127V
-
~ 60Hz T 3A -
220 240V
-
~ 50Hz T 1.5A -
-
8 +
10dB
VOLTAGE SELECTOR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
REPLACE WITH THE SAME TYPE FUSE AND RATING
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
WARNING: SHOCK HAZARD - DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
TPM4200FX MKII V2
115V
23
24
25 26 26 27 28 29
REAR PANEL
These connectors are used to output the signal to the speaker. The minimum speaker load is 2 ohms.
25- OUTPUT
23- LEVEL CONTROL
This control is used to adjust the level of TAPE IN. The adjustable range goes from -
to +10dB.
The unit features dual RCA jacks(left and right). If you wish to listen to your monitor from a tape
recorder, DAT or cassette, please use these TAPE IN jacks. Via the TAPE OUT jacks, you can route the
main output signal into a tape recorder or DAT for recording.
24- TAPE IN/TAPE OUT JACKS