31- Control Room Source
NOTE: When any SOLO switch was engaged, the SOLO signal will replace other signals, and also be sent to
the Control Room, Phones and Meters.
32- PHONES/CTRL ROOM Controls
Rotate these knobs to adjust the stereo level of CTRL ROOM and PHONES outputs separately, which
can be varied from -
to MAX.
You can choose to monitor any combination of MAIN MIX, SUB1-2, SUB 3-4 and 2TK IN via these Matrix
switches. Engaging these switches, the stereo signals will be delivered to the Phones, Control Room and
Meters display.
NOTE: The SOLO function can never affect the mix at main recording output, and also can't be affected
by channel's MUTE switch.
33- SOLO MODE Button
This button provides two modes: up for PFL (Pre-Fader-Listen) mode, down for AFL (After-Fader-Listen)
mode. Engage the button, the soloed signal will output after the Level control, otherwise, release the
button will output the soloed signal before the Level control.
34- POWER LED
The LED indicates when the power is ON.
35- PHANTOM LED
This LED indicates when the phantom power is switched on.
36- LED Meter
The stereo 8-segment LED Meter will indicate the signal level send to the Ctrl Room and Phones outputs.
-TAPE IN
Use the Tape input if you wish to listen to your mix from a Tape Recorder or DAT.
- TAPE OUT
These RCA jacks will route the main mix into a tape recorder.
38- 2-TRACK IN/OUT
These jacks will be used to send the signal to a pair of
headphone or to powered studio monitors.
40- PHONES Jacks
39- USB LAMP socket
This lovable LAMP is very convenient for your operation,
it is located in the top right corner of the front panel,
and provides the 5V socket that can drive standard
USB-type lamp.
42- MAIN INSERT
These two 1/4" phone jacks are stereo insert points and used to connect processors such as compressors,
equalisers etc.. When insert a external processor into the jack, the Main stereo signal will be taken out
after the EQ and returned into the MAIN MIX output before the MAIN MIX fader.
41- MAIN MIX OUTPUT
These stereo outputs are supplied with both the XLR and 1/4" phone jacks
and it is controlled by the Main Mix Level.
37- MAIN MIX LEVEL Fader
This fader sets the amount of signal send either to the Main Mix Output or to the Tape Output.
B
PHONES
A
L
TAPE IN
R
TAPE OUT
2-TRACK IN OUT
INSERT
INSERT
MAIN MIX
OUTPUT L
MAIN MIX
OUTPUT R
5V
0.5A
LAMP
BAL UNBAL
BAL UNBAL
24-CH COMPACT INTEGRATED LIVE
SOUND MIXER
MX2442
1
2
3
1
2
3
