Toplicht BLAKES LAVAC Popular 4610-000, Руководство пользователя, Страница: 30 / 31

30
Blockages in the pump
If a blockage occurs in the pump, first pour half a bucket of water in the
bowl and then, with the lid open, pump with even firm strokes until the
water leaves the bowl.
This should clear the pump but repeat if necessary and then close the lid
and pump again to replace the correct amount of water in the bowl.
If the pump will not operate and empty the bowl, remove the front cover of
the pump. This is a quick release fitting that has to be turned in an anti-
clockwise direction to unscrew. A bucket should be held below the pump
whilst doing this as the contents of the pump will escape. (Note: the old
Mark 3 pump has fixing screws to the front cover.)
Check that the inlet and outlet valves are not being held open by an
obstruction. If so, remove the obstruction. Replace the front cover and
seal and check the operation of the pump. If it still does not operate (i.e.
empty the bowl with the lid open) it will be necessary to remove the pump
body from the pump base by unscrewing the 8 bolts around the octagon
perimeter and replacing the valves.
See page 25-26 ‘
When re-assembling the pump, ensure that all screws are tight (not over-
tight). If air can be drawn into the pump, the toilet will not operate.
1
2
3
4
Operational Solutions