3.1 Searching for broadcasting services 15
3.1.2 Configuring DiSEqC 1.2 settings
Your motorized antenna will turn toward your desired satel-
lites horizontally by DiSEqC 1.2.
When you switch to a service, if it is not
provided by the current satellite, it will take
longer time than usual because the antenna
has to turn to its position.
To use the DiSEqC 1.2 protocol,
select the
Installation
>
Motor-
ized DiSEqC 1.2
menu.
You
should see a screen like the left
figure. At first you have to set the
Motorized DiSEqC 1.2
option to
Enable
.
To get the correct position of your desired satellite, take the
following steps:
1. Choose your desired satellite at the
Satellite Name
op-
tion.
2. Set the
DiSEqC Command Mode
option to
User
.
3. Set the
Motor Control
option to
Goto
. Then the antenna
will turn toward your selected satellite by the position
data that the digital receiver has.
4. If the receiving quality is not good, tune the antenna
finely with the
Movement
option. If you set it to
2(E)
,
the antenna will move to the east by two degrees. At this
time you had better check the receiving quality of every
transponder and choose the best one at the
Transponder
