13
Warning Light (Included in some models, refers to the actual package)
The red wire of the warning light should be inserted into
LAMP (#11)
terminal, the white wire into the
LAMP-
(#12)
terminal.
Back-up Battery & Solar Panel & Solar Controller (optional)
If there is
no solar panel
to be used for charging the battery, then the
“24V+”
of the battery should be wired to
the
BAT+ (#19)
terminal.
“24V-”
should be wired to
“BAT-” (#18)
terminal.
The battery could also be charged by the solar panel & solar controller. Please refer to the manual instruction of
solar panel and controller separated for wire connection.
Photocell Beam System (PBS) (Included in some models, refers to the actual package)
Use a 2-core cable to connect the
“- ~”
terminal of the photocell’s emitter to the “14” terminal, the
“+ ~”
terminal
to the “13” terminal. Also the
“- ~”
and
“+ ~”
terminals of the photocell’s receiver should be connected to the
“14” and “13” terminals in parallel.
Use another 2-core cable to connect the
“COM”
terminal of the receiver to the “15” terminal, the
“NC”
terminal
to the “16” terminal.
Push Button (optional)
The push button should be wired to the
GND
(#16) and
O/S/C
(#17) terminals. The gate operator works
alternately by pushing the button (open-stop-close-stop-open).
External Receiver (optional)
The
BROWN
wire of the external receiver should be connected into the “17” terminal.
The
BLACK
wire of the external receiver should be connected into the “16” terminal.
The
RED
wire of the external receiver should be connected into the “13” terminal.
Wired Keypad (24VDC) (optional)
The
RED
wire of the wired keypad should be connected into the “13” terminal.
The
BLACK
wire of the wired keypad should be connected into the “14” terminal.
The
PURPLE
wire of the wired keypad should be connected into the “16” terminal.
The
BLUE
wire of the wired keypad should be connected into the “17” terminal.
How to Program or Erase the Remote
The remote MUST be programed to the opener BEFORE OPERATING. Please follow the steps to
program the remote.
Activate the opener only when gate is in full view, free of obstruction and properly adjusted. No one
should enter or leave gate area while gate is in motion. DO NOT ALLOW CHILDREN to operate push
button or remote. DO NOT ALLOW CHILDREN TO PLAY NEAR THE GATE.
If you purchase additional remote controls, the gate opener must be programmed to accept the new
remote code.
If you lose one of any remote control, please erase and reprogram all other remote controls to have a
new code for safety.
Program the remote
Press and release the learn button, the
LED
will display
“Ln”,
then press
the key in the remote twice in 2 seconds, the
LED
will flash
“Ln”
for 4
seconds then back to
“- -”
. Now the remote has been programed
successfully.
Erase all the remote codes
Press and hold the learn button until the
LED
display “dL”, release the
button and the LED will be back to
“- -”
. Now all remote codes have been erased.
Содержание AT602
