2025001032 Revision L, 10/16
INTRODUCTION
Thank you for purchasing the TOPCON AIT Table.
This User’s Manual covers models AIT-250W, AIT-350W, AIT-650, AIT-W1, and AIT-W2.
The primary difference between these models is the shape of the top and floorplate.
The AIT Table is a state-of-the-art table that provides the ultimate Ophthalmic and Optometric instrument
delivery. The unit is intended to hold the diagnostic instruments and to facilitate the proper adjustments for
the operator and the patient.
Please carefully read this user’s manual to get the best system performance, and place the manual in a
convenient location for future reference.
PRECAUTIONS
1.
Installation. Never position the unit where it will be exposed to moisture, direct sunlight, dust, salty air,
chemical storage areas, excessive temperature or humidity. Install the unit in a stable place, free of
uneven floors, vibration and shock.
2. Prior to Operation. Always check that all the cords are properly connected.
3. Operation. Take the proper steps to stop the unit (leaving the patient in a safe condition) if anything is
found wrong with the unit.
4. After Operation. Never hold and pull the connecting cord for disconnecting plugs. Excessive force may
be applied and cause damage to the inside connections. If the unit has not been used for a long period of
time, check the operation and safety features before using it again.
SAFETY CONCERNS
The AIT Table conforms to UL 60950-1, CSA-22.2 No. 60950-1, and IEC 60950-1. Any of the defined
optional equipment can be added to the AIT Table without any additional safety hazards being introduced
and there is no disposal of any waste products associated with the AIT Table.
WARNING: The installation of the AIT Table shall only be performed by a
qualified technician.
!
WARNING: All service and repairs shall be performed by a qualified technician.
!
WARNING: All replacement parts or optional equipment shall be genuine Topcon
parts. Contact Topcon or your dealer for those items.
!
WARNING:
The AIT Table is designed for use with TOPCON equipment.
If any other equipment is used, it shall meet the same certifications.
!
