11
Operation procedures
Operation procedures
Preparations
1
Place the instrument at the same level as the person to be measured.
When installing by using the base, insert the shaft of the instrument into the base as
illustrated. (This method is same when using the stand or wall mount.)
2
Turn the power switch 'off'.
3
When more than two instruments are installed in close proximity to each other, it is
necessary to set the channel by the DIP switches of the body and the signal channel
switches of the remote controller in order to avoid interference.(Up to four instru-
ments may be installed at the same location)
*
At the time of shipment, the instrument is set at channel 1.
*
To change the channel, see "Changing the channel setting of the remote controller"
on page 26.
Caution
Do not tilt the device or place it in an unstable place. Otherwise,
the device may topple over, drop or cause injury.
Warning
Connect the power plug to a three-prong properly grounded AC
socket with an earth. If it is connected to a socket that is not
grounded, it can cause a fire and electric shock due to leakage.
Caution
Handling the power plug with wet hands can cause electric shock.
Caution
When this instrument is not used for a long time, remove the bat-
teries from the remote controller.
Base (Some types do not have
it in the standard kit.)
