Topcon 1004089-01, Руководство по настройке

Страница: 37 / 58

Chapter 3
– Tuning Preparation
23

Universal terminal:
2. Drive the vehicle forward to start the procedure. The wheel angle
sensor calibration should be completed at approximately 2 kph
(1.2 mph).
3. Turn the steering wheel full lock to the left and select next. The
console will beep and move to the next step once calibrated.
4. Turn the steering wheel full lock to the right and select next. The
console will beep and move to the next step once calibrated.
5. Ensure the vehicle is still moving at 2 kph (1.2 mph). Turn the
steering wheel as close as possible to the center position
Note
: Finding the center position and driving in a straight line,
before selecting Next, is crucial for system performance.
6. Select next.
7. The system will begin to save calibration data. Wait until the
screen states that the calibration is completed successfully and
then confirm.
3.5.5. Hydraulic system calibration
Note : This is only applicable to ACU-1 installations.
WARNING: During hydraulic calibration, the vehicle
will automatically move the front axle wheels
progressively to the left position and then progressively
to the right when Next is selected. The calibration can
take up to 60 seconds in this mode.
Ensure there is sufficient space for the tractor to
complete a progressive turn to the left, right and to move
straight ahead before selecting Next.
It is recommended to remove the implement if it is a
trailed, pivoted type implement to avoid possible damage
to the implement or vehicle.
1. When ready and confident that your pathways left, right and
ahead are clear, select Next to continue.