6.1.
Electrical Connection
WARNING
Do not plug your appliance to a multi-socket or do not use an extension cord
Your product is not equipped with an on/off switch.
Do not allow the cables of your product connected to the mains to contact hot surfaces.
Outlet that shall be used shall always be grounded. It the outlet that shall be used shall also be protected with a
proper fuse with a rating of 10-16 A minimum. Be sure to seek help from our technical service or a qualified
electrician regarding the insurance that must be present in the network to which your outlet is connected.
The mains voltage and frequency must be the same as the value written in the label information on the inside of
your product. If mains power is far below or above the specified value, have the desired voltage by using a voltage
regulator. You can get help from a qualified electrician.
Do not put the cable of your product on passage routes. These may cause injury to you and damage to your cooler.
If the power supply cable is damaged, it must be replaced by its manufacturer or authorized technical service or any
other personnel qualified at the same level, in order to avoid any dangerous situation.
6.2.
Operation of Your Cooler
•
Clean the inside of your product and all of its accessories before operating your product for the first time.
•
If your product has been shaken a lot during transport and placement, allow at least two (2) hours before
starting to use your cooler. Thus, compressor oil shall be returned if it has entered the system. You may
damage the compressor if you operate the cooler without considering this.
•
Plug your product to an outlet that is installed as per the legislation and that supplies a 220 - 240V / 50 Hz
alternative current only.
•
You shall hear a slight compressor noise when your product is operated.
•
Fan inside your product shall stop when you open the door of your cooler.
6.3.
Setting the interior temperature of your cooler
•
For Coolers with LCD Display (Optional);
•
Temperature settings of your appliance is performed in our factory for operation in suitable conditions.
•
Temperature for the preservation of the food is adjusted with the thermostat by observing it from the
thermometer on your cooler (optional). However, it is best to keep this at factory setting.
•
Internal temperature of your cooler may be adjusted by rotating the thermostat switch. When the
thermostat is in
position “6”, the temperature inside the cooler will be on the lowest level and when in position “1”, it will be
on highest level.
•
Internal temperature of your product may be set between -18 and -24 C.
