HINGE KNEE PLUS
APPLICATION INFORMATION
A Unfasten and loosen the straps at the thigh and calf.
B Pull the Sleeve onto the leg using the loops at the top of each hinge bar.
The wrap-around brace is applied with the closures in the front of the leg,
and the patella (knee cap) cut out is centered over the front of the knee.
Secure the closures firmly starting with the lower portion & finish with upper.
C Fasten the lower calf strap first (#1), then the upper thigh strap (#2).
D With the knee bent at 30°, push both condyles (hinges) toward the back of
the leg, as shown.
E Maintaining the position of the hinges, secure the lower thigh strap (#3).
F Next, tighten the upper calf strap (#4).
D Maintaining the position of the hinges at 30°, secure the upper calf strap (#3).
E Draw the hinges forward slightly before fastening the front thigh strap (#4).
Do not pull the hinges beyond midline of the leg.
D With the knee bent at 30°, push both condyles (hinges) toward the back of
the leg, as shown.
E Maintaining the position of the hinges, secure the lower thigh strap (#3),
and then the upper calf strap (#4) on the back of the leg.
Warranty
Top Shelf Orthopedics guarantees this product to be free of defects in material and construction for
a period of six months from date of purchase.
Please read the following instructions before using this product. Correct application is critical
to the proper function of the brace.
• If the wearing of this device causes increased pain or swelling or if the sensation in your leg changes please consult
your medical professional immediately.
Make sure that all wounds are covered with a dressing if they are still healing PRIOR to putting this device on your leg.
Warnings and Precautions:
ACL configuration sleeve version only
PCL configuration sleeve version only
CI configurations sleeve and wraparound versions
Hinge Adjustment Instructions
To change the stops, completely remove
both screws from the hinge. Next, slide
the hinge cover off.
Insert the new stop, reapply the hinge
cover and reinsert and completely tighten
both screws. Repeat the procedure on the
other hinge. Both hinges must be identical
in degree.
Stops Included
Extension 0°, 10°, 20°, 30° & 40°
Flexion 45°, 60°, 75° & 90°
(no flexion stops are installed)
The brace is shipped with a 10° extension stop installed. If it is requested by a licensed
healthcare professional, the stops may be changed.
•
