A
SSEMBLY
G
UIDE
1. Insert Filter Assembly
Insert Filter Assembly into Dust Tank with Cyclone Cup pointing forward. Smaller
cylinder above Cyclone Cup fits into back of Intake Hole. Gently press Filter Assembly
forward until it fits snugly and securely inside Dust Tank (FIGURE 1).
NOTE: For more information on inserting individual filters, see Inserting Filters
section on page 8 of this manual.
2. Connect Dust Tank
Insert large tab on bottom-back of Dust Tank into groove on bottom-front of main unit
body. Swing Dust Tank back until it snaps over Dust Tank Release Button and stays
securely in place (FIGURE 2).
3. Connect Hose
Insert Hose into Intake Hole on top of Dust Tank. To accomplish this, press the two
buttons on sides of hose end inward (FIGURE 3). Then insert Hose into Intake Hole
until it clicks into correct position and stays securely in place (FIGURE 4). To remove
Hose, repeat process and reverse by pulling Hose out from Intake Hole.
4. Deploy Power Cord
Grasp plug of power cord firmly and pull out from compartment on back of unit to
desired length (15 ft. maximum) (FIGURE 5). To retract power cord back into storage
compartment, unplug it from wall outlet and press Cord Retraction Button on top of
unit. Hold button down until cord is completely retracted (FIGURE 6).
WARNING: Extend power cord ONLY to yellow mark on cord, as this indicates
maximum safe length. DO NOT extend cord to red warning mark.
6
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6
Top Innovations, Inc.