2
o
2. Remove the 3mm set screws that were included with the
axles in the hardware package. Apply a drop of threadlocker
to the set screws and install them in the new axles. Slide
the new axles onto the landing gear wires tightening the set
screws on the flats at the end of the wires. Note the direction
of the axles.
o
3. Apply a drop of threadlocker to the threads of a 6-32
x 1/4" [6.4mm] socket head bolt. Install the bolt in a 4mm
wheel collar. Slide the wheel collar onto the axle and tighten
the 6-32 bolt. Slide a 3-1/4" [82mm] foam wheel on the axle
and secure the wheel with a second wheel collar. Make sure
the wheel turns freely.
o
4. Insert the retracts in the retract openings in the wing.
Adjust the position of the retracts so that the retract body
is centered on the mounting rails. Adjust the position of the
axle on the landing gear wire so that the wheel is centered
in the wheel well.
o
5. On the retract mounting rails, mark the four retract
mounting holes. Remove the retracts and drill a 7/64"
[2.7mm] pilot hole at each mark.
o
6. In one end of a 1/16" x 12" [1.6 x 12.7mm] wire
pushrod make a Z-bend. Insert the Z-bend in the nylon
horn on the retract.
o
7. Insert the retract wire in the retract pushrod tube.
Position the retracts on the retract rails. Secure the retracts
to the rails using four #6 x 1/2" [12.7mm] sheet metal screws.
Operate the retracts by pushing and pulling the retract wire.
Continue with the installation of the retract servo.
Содержание Giant Scale Gold Edition P-51D Mustang
Страница 4: ......
