Top Auto BRK600, Руководство пользователя

Страница: 12 / 27

USER MANUAL, MAINTENANCE AND SPARE PARTS
Rev. 01-2020 PAGE. 12 BRK600
4 OPERATION AND USE
4.1 DESCRIPTION OF THE MACHINE OPERATION
The machine referred to in this manual has been designed and built for the replacement and discharge of brake fluid from brake
and car clutch systems. The liquid is constantly pumped into the brake liquid tank with a pressure of 0 to 4 bar. The liquid to be
replaced can therefore be discharged through the individual bleeding valves of brake calipers until the new liquid comes out. This
technique avoids the formation of air bubbles in the system and avoids the typical annoying pouring operations.
4.2 MACHINE CYCLES
1) Extraction

The pump extracts the exhausted brake fluid from the specific pan in the engine compartment until completely emptied.
2) Connection

The adapter ca be found in the specific kit and connects to the pan instead of the original cap.
3) Charging new liquid

The pan is filled up to the expected level.
4) Bleeding old liquid

The exhausted liquid is extracted from the system through the bleeding valves.
5) Disconnection

The pressure is bled by the specific valve and the adapter is disconnected by putting the original cap back on the pan.
4.3 INTENDED AND UNINTENDED USE
The machine in question has been designed and built for the above use. The machine must not be used for uses other than those
specified here.
It is forbidden to:

Use the machine with a different liquid than the indicated one in this manual.

Modify the operation principle of the machine in any way by adding or removing components to it.

Use the machine in explosive and/or fire-risk environments.

Plug in the machine to energy sources other than those envisaged by the manufacturer

Use commercial devices for a purpose other than the manufacturer intended.
ATTENTION It is the obligation of the employer (or safety officer) to ensure that the machine is not used improperly,
endangering the health of the operator and exposed persons. It is the worker's obligation to inform the employer (or the
safety officer) if there is a danger of improper use of the machine because, as an educated person, the worker is respon-
sible for the machinery use he is going to carry on.
4.4 WORKSTATIONS FOR OPERATORS
The machine is designed to work in the presence of an operator. The presence of an operator is provided for the connection
and disconnection of the machine to the vehicle as well as to setup and switch off the cycle.
The dismantling of the protective casings and the consequent access inside the machine is provided only for maintenance and
cleaning operations.