14
GENERAL CUTTING
DANGER:
Always clamp the workpiece
firmly into a vise or to a stable work surface.
Never hold the workpiece with one hand and
the tool with the other hand. Severe injury
may result.
WARNING:
Always wear appropriate
eye, ear and breathing protection and
protective clothing when operating the cut-
off tool.
1.
Mark the workpiece where the cut is to be
made.
2.
Firmly clamp the workpiece in a vise or to a
stable work surface.
3.
Grasp the tool with both hands, turn the
tool ON and wait until it reaches full speed.
4.
Carefully place the edge of the cutting disc
onto the workpiece surface.
5.
While cutting, keep the tool moving over
the workpiece, while maintaining a steady
pressure on the cut-off disc.
NOTE:
Do not force the tool by applying
too much pressure. The tool will slow down
and will not cut properly. It will also
damage the motor.
6.
When the cut is completed, release the
ON/OFF switch and allow the cut-off disc to
stop before putting the tool down.
GENERAL
WARNING:
When servicing, use only
identical replacement parts. The use of any
other part may create a hazard or cause
product damage.
DO NOT use solvents when cleaning plastic
parts. Plastics are susceptible to damage from
various types of commercial solvents and may
be damaged by their use. Use a clean cloth to
remove dirt, dust, oil, grease etc.
WARNING:
Do not allow brake fluids,
gasoline, petroleum-based products,
penetrating oils, etc. to come into contact
with plastic parts. They contain chemicals
that can damage, weaken or destroy plastic.
DO NOT abuse power tools. Abusive practices
can damage the tool and the workpiece.
WARNING:
DO NOT attempt to modify
tools or create accessories. Any such
alteration or modification is misuse and
could result in a hazardous condition leading
to possible serious injury. It will also void
the warranty.
It has been found that electric tools are
subjected to accelerated wear and possible
premature failure when they are used for cutting
and grinding metals. The grindings from these
materials are highly abrasive to electric tool
parts such as bearings, brushes, commutators,
etc. Consequently, it is not recommended that
this tool be used for extended work on any
metals. During any use on these materials it is
extremely important that the tool is cleaned
frequently by blowing it out with an air jet.
WARNING:
Always wear safety goggles
or safety glasses with side shields during all
cut-off and grinding operations. It is critical
that you also wear safety goggles or safety
glasses with side shields and a dust mask
while blowing dust out of the cut-off tool
with an air jet. Failure to take these safety
precautions could result in permanent eye or
lung damage.
LUBRICATION
All of the bearings in this tool are lubricated with
a sufficient amount of high-grade lubricant for
the life of the unit under normal conditions.
Therefore, no further lubrication is required.
ASSEMBLY AND
OPERATING
MAINTENANCE
!
!
!
!
!
MAINTENANCE
!
Содержание 241-9970
Страница 15: ...15 EXPLODED VIEW...
