Toolshop 241-9970, Руководство пользователя

Страница: 13 / 17

13
INSTALLING THE CUTTING DISC – cont’d
ON/OFF SWITCH
WARNING:
Before starting the tool, make
sure the cutting disc is in good condition, is
properly installed and not in contact with any
surface.
This tool has a combination lock-out and
ON/OFF switch to avoid unintentional starting of
the tool. To turn the switch ON:
1.
Grasp the tool with two hands.
2. Press downward on the rear of the
ON/OFF switch with your thumb (Fig. 4).
3. While pressing downward on the rear of
the ON/OFF switch, slide the switch
forward to start the tool.
NOTE: The ON/OFF switch will click into
the lock-on position when the switch button
is pushed fully forward. The tool will
continue to operate until the switch is
turned OFF.
4. To turn the tool OFF, press downward in
the rear of the switch button.
Fig. 3
ASSEMBLY AND OPERATING
!
Fig. 4
For safety reasons, the operator must
read the sections of this Owner’s Manual
entitled "GENERAL SAFETY
WARNINGS", "POWER TOOL SAFETY",
"SPECIFIC SAFETY RULES",
"EXTENSION CORD SAFETY" and
"SYMBOLS" before using this cut-off
tool.
Verify the following every time the cut-off
tool is used:
1.
The cut-off disc is in good condition
and properly installed on the tool.
2. The guard is properly positioned on
the tool and in the correct position
to protect the operator.
3. The workpiece is firmly clamped in a
vise or to a stable work surface.
4. Safety glasses and appropriate
safety gear are being worn.
5. No flammable liquids or materials
are in the area.
6. All bystanders are well clear of the
area.
Failure to observe these safety rules will
significantly increase the risk of injury.
WARNING
!