6
Specific Safety Rules for Stapler
1.
KEEP WORKING AREA CLEAN.
Cluttered areas invite injuries.
2.
DON’T ALLOW CHILDREN KEEP AT THE WORKING AREA.
Don’t let them handle the tool.
3.
DO NOT OPERATE THIS TOOL IF UNDER THE INFLUENCE OF ALCOHOL OR DRUGS.
Read warning label on prescriptions to determine if your judgment or reflexes are impaired while taking
drugs. If there is any doubt, do not attempt to operate.
4.
USE SAFETY GLASSES.
Safety glasses should conform to ANSI Z87.1 specifications. Before
operating, wear safety glasses against flying debris from the front and side. Safety glasses should be
worn when loading, operating, unloading or servicing this tool.
5.
USE EAR PROTECTION.
The working area may be exposed to high noise levels that can lead to
hearing damaged.
6.
NEVER USE OXYGEN COMBUSTIBLE GASES, BOTTLED GASES OR HIGH PRESSURE
COMPRESSED GAS AS A POWER SOURCE FOR THIS TOOL.
The tool may explode and cause
serious injury.
7.
DRESS SAFELY.
Protective gloves and nonskid footwear or safety shoes are recommended when
working with and operating this tool. Don’t wear loose clothing or jewelry. They can get caught in
moving parts. Also, wear a protective hair covering to prevent long hair from getting caught in the tool.
8.
DO NOT FIRE TO HARD MATERIALS.
Do not attempt to shoot toward hard or brittle material
such as concrete, steel or tile.
9.
WHEN OPERATING TOOL.
keep the proper footing and balance to avoid damaged resulting from
losing balance.
10.
CHECK DAMAGED PARTS.
Before using tool, carefully check if there is any part damaged.
11.
REPLACE PARTS AND ACCESSORIES.
Only allow use same replacement parts while servicing.
Approved accessories and replacement parts are available.
12.
KEEP ALERT.
Watch what you are doing. Use common sense. Do not operate any tool when you are
tired.
13.
STORE THE TOOL.
When not in use, tool should be cleaned, fully assembled and then, stored in a
dry location to reduce rust. For safety, keep out of reach of children.
14.
OUTDOORS EXTENSION CORDS.
When air compressor is used outdoors, use only rounded
jackets extensions cords intended for outside use. See manufacturer’s manual for the AWG required for
the compressor’s amperage draw.
15.
PAY ATTENTION TO AIR HOSE AND THEIR CONNEATIONS.
Don’t trip over hoses. Make
sure all connections are tight.
16.
AFTER LOADING THE FASTENERS.
never point the tool at yourself or bystanders.
17.
USE THE CORRECT AIR CONNECTOR.
The connector on the tool must not hold pressure when
the air supply is disconnected. If the wrong fitting is used, the tool can be charged with air after being
disconnected and still be able to drive a fastener.
18.
WHEN CONNECTING THE AIR.
The tool can possibly fire the fasteners. Therefore, remove all the
fasteners before connecting to the air.
Содержание 208-2136
Страница 1: ......
Страница 8: ...8 Know Your Stapler 1 Latch 2 Contact Tip 3 Magazine 4 Lock 5 Air Plug 6 Trigger...
Страница 12: ...12 Exploded View...
