Toolots NAX Series, Инструкция по эксплуатации

Страница: 13 / 16

13
1
The geometric
accuracy of the
cut part exceed
requirement Loose jaw Fasten the working part
Saw band and the working
table are off plumb
Adjust working table
Saw band worn or broken Replace saw band
2
Smoking while
cutting The cooling liquid could not
flow out fluently Dredge the cooling
pipes
Fast feeding Adjust the speed
Saw backbone not straight Rubdown or replace
3
Blue or purple
iron chips Too fast saw band speed Change saw band
position and slow down
saw bank speed
4
Saw Break Too fast feeding Measures shall be taken
according to different
situations
Saw overstretched or less
stretched
Working part unfastened
5
Cutting
Vibration Too fast saw band speed and
feeding Adjust the speed
Saw backbone not straight Repair or replace
6
Active Drive
System
Spinning
Saw Band
Touches Tooth Loose drive belt Stretch the belt
Too much stretching tension
of saw band
Adjust stretch tension
of saw band
Too fast feeding Adjust the speed
Bad quality cooling liquid Replace by good
quality cooling liquid
Improper tooth gap Choose the right tooth
Working part unfastened Fasten the working part
Too much feed Decrease the feed