ToolMaster TM-U3, Инструкция по эксплуатации

Страница: 26 / 36

LATHE TOOL GRINDING ATTACHMENT
Change the original workhead with ithe Lathe tool attachment (as displayed below)
|nsert the Lathe tool bit into the Lathe tool attachment workhead and fasten it, so that the Lathe tool bit will
not move
Set the center of Lathe grinding attachment at the height of the grinding wheel at the spindle center.
Recommended Angles and Relief
Each manufacturer have their own recommended relief angle for machining differt material . Consult the
manufacturer for the desired angles and releif
Side Cutting Edge Angle
Set the lathe tool grinding attachment horizontally by the degree required for the side cutting edge angle for
grinding the the side cutting edge angel (A), Tilt the lathe tool grinding attachment vertically by the recom-
mended side rake angle (B) to grind the side rake angle (as drawing below)
End Cutting Edge Angle
Set the lathe tool grinding attachment horiznotally by the degree of the angle for the end cutting angle
grinding required for grinding the end cutting edge angle (C), Tilt the lathe tool grinding attachment vertically
by the recommended end rake angle (C) to grind the end rake angle (as drawing below)
Secondary Relief Angles
Repeat the processes above to grind the secondary relief rake angle.
Back Rake Angle
Adjust the lathe tool grinding attachent to a verrtical position and set the positive or negitive back rake angle
(F)