4
www.machineryhouse.com.au
www.machineryhouse.co.nz
Any missing parts or damage should be reported immediately to your Toolmaster distributor. Do not use
a damaged tool. Read this instruction manual thoroughly for operation, maintenance and safety
instructions. The diagram below is the ideal setup position. The lubricator is optional and if not used, then
a few drops of Pneumatic Tool Oil need to be added to the airline connection before operation. Add a few
more drops after each hour of continual use.
WARNING:
Operating the tool at pressures over the rated capacity may cause severe
damage and/or personal injury. Do not exceed 90 PSI while operating the tool. Do not
use an accessory rated at a lower maximum pressure than the tool.
C
ompressor
A
ir
H
ose
F
ilter
r
egul
Ator
l
ubri
CAt
or
A
ir
H
ose
C
oupler
& F
itting
t
ool
F
ig
. 1
Setup
The recommended air system is shown in Fig.1.
1. Use proper air hose size (refer to tool specifications). The hose should be just long enough to
serve the working area. Excessive hose length will cause pressure drop.
WARNING!
Ensure that the air supply is clean and does not exceed 90psi. Too high an air
pressure and/or unclean air will shorten the life of the air tool due to accelerated wear,
and may cause damage and/or personal injury.
2. Drain the compressor air tank daily. Water in the air line will damage the air tool.
3. Clean the compressor air inlet filter screen weekly.
4. Line pressure should be increased to compensate for unusually long air hoses (over 8 meters).
The minimum hose bore should be 10mm and fittings must have the same inside dimensions.
5. Keep hoses away from heat, oil and sharp edges. Check hoses for wear, and make certain that all
connections are secure.
IMPORTANT:
The leader hose is optional, but connecting a quick-change coupling directly to the
tool is not recommended, as vibration may cause the connection to fail. For the best result, add a
leader hose and install any quick-change couplings farther down the line.
Air Supply
l
eAder
H
ose