Toolland TM82000, Руководство пользователя

Страница: 5 / 28

TM82000
V. 01 – 15/07/2016 5 ©Velleman nv
 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
 Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
 Keep this manual for future reference.
4. Features
 ergonomic soft grip
 rotating handle
 LED work light and built-in flash light
 LED power indicator
 spindle-lock function
 included: ● 49x 25 mm bits ● 1x 60 mm magnetic bit holder ● 1x charger ● 1x gift box
5. Overview
Refer to the illustrations on page 2 of this manual.
1 keyless chuck 6 direction switch
2 torque setting 7 power trigger
3 work LED 8 work light switch
4 battery level 9 power input
5 handle locking button
6. Charging the Battery
WARNING
Do not puncture batteries or throw them in fire as they may explode. Do not
attempt to recharge non-rechargeable batteries (alkaline). Dispose of batteries in
accordance with local regulations. Keep batteries away from children.
WARNING
Place the device and charger on a flat, non-flammable surface and away from
flammable material during charging.
1. Connect the device to the charger.
2. Insert the plug of the charger into the mains.
3. Check the charging status of the device:
Red LED: The battery pack is insufficiently charged. Please recharge.
Yellow and red LED: The battery has an adequate remaining charge.
All LEDs: The battery is fully charged.
4. Disconnect from the charger and insert in the device. Disconnect the charger from the mains.
7. Using Your Drill
WARNING
Before using the device, inspect it to ensure there is no excessive wear. Never use a
damaged drill bit.
1. Make sure the battery is sufficiently charged.
2. Place the direction switch to the middle position in order to lock the power trigger.
3. Press the chuck ring towards the device and insert an appropriate bit. Release the chuck.
4. Place the direction switch at the desired position. Press the power trigger to use the drill.
5. Adjust the torque if needed.
6. The handle can also be adjusted. To do so, press and hold the handle locking button while turning the
handle. Lock the handle by releasing the handle locking button.