Toolex MIG-200, Инструкция по эксплуатации

Страница: 22 / 26

37 301008158 CO2 flange English style PCS 1
38 301008156
CO2 central plug
receptacle
English style PCS 1
39 303018056 digital display meter LXD5135-2V/1999 PCS 2
40 303017010 rocky switch MR1-120-C5N-BBAAE PCS 4
41 2050131724 front panel for ADVAN MIG 250 PCS 1
42 301008150 quick receptacle 35-70 PCS 2
43 303002045 potentiometer 2W/47K PCS 1
12\26 304014033
circuit board Dustproof
box
For IGBT machine (EAC0-12) PCS 2
12\26 304014034
cover for circuit board
Dustproof box
For IGBT machine(EAC0-13) PCS 2
16\30 303021029
temperature
controller
KSD301 close-250V/10A-75 ℃ PCS
2
TROUBLESHOOTING
IMPORTANT!
BE CERTAIN to shut off the Welder, disconnect it from power, and discharge the
torch to ground before adjusting, cleaning, or repairing the unit.
Wire feed motor runs but wire does not feed properly
Possible causes and solutions
1. Insufficient wire feed pressure:
Increase wire feed pressure properly - follow instructions on page 11-12.
2. Incorrect wire feed roll size:
Replace with the proper one - follow the wire spool instructions on page 11.
3. Damaged torch, cable, or liner assembly:
Have a qualified technician inspect these parts and replace as necessary.
Wire creates a bird’s nest during operation
Possible causes and solutions
1. Excess wire feed pressure:
Adjust wire feed pressure properly - follow instructions on page 11-12
2. Incorrect contact tip size:
Replace with the proper tip for the wire size used.
3. Gun end not inserted into drive housing properly:
Loosen gun securing bolt and push gun end into housing just enough so that it does
not touch wire feed mechanism.
4. Damaged liner:
Have a qualified technician inspect and repair/replace as necessary
Welding arc not stable
Possible causes and solutions
1. Wire not feeding properly: