Tool Shed TSBM, Руководство по эксплуатации

Страница: 7 / 15

7
OPERATION MANUAL
www.thetoolshed.co.nz
ADDITIONAL SAFETY FOR MEAT CUTTING BAND SAW
Safety is a combination of common sense, staying alert and knowing how your bandsaw works. Read
and understand the following safety rules before operating.
1. Adjust the upper guide to just clear the workpiece.
2. Make sure the blade is properly adjusted and tensioned before operating.
3. DO NOT remove small, jammed pieces until the blade has completely stopped.
4. Hold item to cut firmly against the table.
5. Turn the machine off if the piece to cut is to be backed out of an uncompleted cut.
6. DO NOT operate this bandsaw using a dull or worn blade.
7. After cutting meat, always sanitize and clean all exposed parts.
BEFORE EACH USE
Inspect your bandsaw.
1. To reduce the risk of injury from accidental starting, turn the switch off and unplug the
bandsaw before changing the set-up, removing covers, guards, or the blade.
2. Check the alignment of moving parts, binding of moving parts, breakage of parts, bandsaw
stability and any other conditions that may affect the way the bandsaw works.
3. If any part is missing, bent or broken in any way, or if any electrical parts do not work
properly, turn the bandsaw off and unplug the saw. Replace damaged or missing parts
before using the bandsaw again.
4. Make sure the blade teeth point downward, towards the table.
5. Make sure the blade guides are properly adjusted.
6. Make sure blade tension is properly adjusted.
7. To reduce the risk of accidental blade contact, minimize blade breakage, and provide
maximum blade support, always adjust the upper blade guide, and blade guard to just clear
the workpiece.
8. Before starting your cut, watch the saw while it runs. If it makes an unfamiliar noise or
vibrates a lot, stop immediately. Turn the saw off and unplug. Do not restart until you have
found and corrected the problem.
9. Let the blade reach full speed before cutting.
CONNECT SWTICH TO MOTOR
The switch has been prewired at the factory to make connection easier. Connect the plugs to each
other during the assembly stage.