28
39 NX=?
Note 3
4
The instrument sends
corresponding setting value once
after receiving the command that
setting value is inquired. Sending
format: {NX=X
1
X
2
X
3
X
4
X
5
X
6
X
7
}.
Refer to command 38 Data format
regulation after being received
and adjusted.
40
P0
2
start, the same function as START
key.
Table 2-6. Format of Serial Command
Note 0: “Command code” should be in the form of ASCII code in the real-world
program. Such as, {0} can be recognized by its ASCII code, 7B41307D.
Note 1: In TH2618B: resistance (R) & dissipation (D).
Note 2: In TH2775B: resistance (R) & quality factor (Q).
Note 3: Defined reference command of NX is 38.
The controller sends continuous command program: sending command 1 —>
the function of making sure that data the instrument sends back are received
has been altered correctly —> sending command 2 again. Recycle these
operations till all the functions are correctly altered.
2.3.5 Sorting mode
Th2810B provides two sorting modes: P3 (default mode) and P1, which are
valid in both direct and
Δ
% display modes.
