15
FUNC
SET
FUNC
START
SET
Figure 2-3. Status Conversion and Keys
Note: some characters are displayed on display window, while some
corresponding letters show in parenthesis in the manual. And the
correspondence of letters and characters is shown in the following table:
For example: When performing short correction,
is displayed,
indicating “CLEAr SH”.
When setting reference value,
is displayed, indicating “ZS”, not “25”.
1.
“measurement” state: Functions are directly indicated on panel, as shown in
Figure 2-2, and corresponding seven commonly-used functions can be
controlled by operating the following cursor keys,
∧
,
∨
,
＜
,
＞
, START.
A.
Measurement parameter: L/Q, C/D, R/Q, Z/Q, Z/D
B.
Measurement frequency: 10 kHz, 1 kHz, 120 Hz, 100 Hz
C.
Test signal level: 1.0V, 0.3V, 0.1V
D.
Display mode: DIR (Direct) and % (Percent
△
deviation) in display A
E.
Range mode: HOLD & AUTO
F.
Measurement speed: FAST & SLOW
G.
Clear (CLEAr): SHORT & OPEN
2.
“inner function” state: seven inner functions are available:
A.
Alarm (1--bEE): OFF & ON
B.
Trigger (measurement mode) (2--ONE): OFF (continuous) & ON (single)
C.
Equivalent mode (3--EqU): series (SEr) & parallel (PAr)
D.
Sending is allowed through serial interface (4--rSC): OFF (only receiving
allowed) & ON (both receiving and sending allowed)
E.
Sorting mode (5--Sor): P1 & P3
F.
Signal source resistance (6--rES): 30
Ω
& 100
Ω
G.
Key lock (7--Loc): OFF & ON
3.
“parameter setup” state: sorting parameters and limits can be set.
A.
Reference value setup: LS, CS, RS, ZS
B.
High limit of dissipation setup (d
-
), or low limit of quality factor setup (q
-
)
C.
High limit of Bin 1 (P1
-
)
D.
Low limit of Bin 1 (P1
-
)
Inner function
Measurement
Parameter setup
