If there is a crack in the body of the electric scooter, wipe it with a small amount of water with a soft cloth. If it is difficult to
clean, you can use a toothbrush with toothpaste to brush it repeatedly and then use a damp cloth to clean it. If the body
plastic has scratches, you can use sandpaper or other abrasive materials for polishing.
Note:
It is forbidden for non-professionals to remove the batter y pack. Failure to do so may result in serious electrical faults or
safety short-circuits.
Disc
brakes debug
If you feel the brake is tight when you are riding, you can adjust the disc brake by loosing the screw on the Rotar y
Knob with a M5 hex wrench(As shown in below picture), turn the Rotar y knob to the right by a little and tighten the
screw with a M5 hex wrench. If you feel the brake is loose. you can turn the Rotar y knob to the left by a little after
loosing the screw on the Rotar y Knob with M5 hex wrench, and then tighten the screw.
Rotar y knob
M5
- 20 -
- 21 -
Handle
shake
debug
If you feel the standpipe is loose and shakes when you are riding, please use the M5 hex wrench to reinforce
the screw as below picture referred.
Use of inflatable mouth
When the front and rear wheels of the electric scooters have insufficient air pressure, inflate the tires with air tube. First,
unscrew the air cap on the tire, and then tighten the extended inflatable tube and air tube on the tire, and connect the
inflator to the air tube on the tire to inflate.
M5
M5
M5
Don't twist the screw
unless it ’s necessar y
!
