Turning off wall switch is not suffi-
cient. To avoid possible electrical
shock, be sure electricity is turned off
at the main fuse or circuit breaker box
before wiring. All wiring must be in
accordance with National and Local
codes and the ceiling fan must be prop-
erly grounded as a precaution against
possible electrical shock.
!
WARNING
How to Wire Your Ceiling
Fan and Install the Control
If you feel that you do not have
enough electrical wiring knowledge
or experience, have your fan
installed by a licensed electrician.
1.
Pull the wire leads, coming from
the end of the downrod, and the
supply wires through the open
side of the hanger bracket
(Figure 14).
2.
Connect the green grounding wire
from the hanger ball, the green
grounding wire from the hanger
bracket to the grounding conduc-
tor of the supply (this may be a
bare wire or wire with green
colored insulation). Securely
connect wires with wire connec-
tors (supplied) (Figure 14).
Failure to seat tab in groove could
cause damage to electrical wires and
possible shock or fire hazard.
!
WARNING
To avoid possible fire or shock, do not
pinch wires between the hanger ball/
downrod assembly and hanger bracket.
!
WARNING
OUTLET
BOX
HANGER
BRACKET
HANGER BALL/
DOWNROD
ASSEMBLY
THREADED
STUD (2)
NOTE: CEILING COVER, SUPPLY WIRES AND
FAN WIRES OMITTED FOR CLARITY.
Figure 13
CAUTION: To reduce the risk of elec-
trical shock, disconnect the electrical
supply circuit before installing the
fan and wall control.
Figure 12
2.
Securely attach the hanger brack-
et to the outlet box using the two
screws supplied with the outlet
box (Figure 12).
Hanger bracket must seat firmly
against outlet box. If the outlet box is
recessed, remove wall board until
bracket contacts box. If bracket and/or
outlet box are not securely attached,
the fan could wobble or fall.
!
WARNING
TAB
HANGER
BRACKET
OUTLET
BOX
TWO SCREWS
SUPPLIED WITH
OUTLET BOX
3.
Carefully lift the fan from the sty-
rofoam packaging and seat the
hanger ball/downrod assembly on
the hanger bracket that was just
attached to the outlet box (Figure
13). Be sure the groove in the ball
is lined up with the tab on the
hanger bracket (Figure 12).
CAUTION: To reduce the risk of elec-
trical shock, disconnect the electrical
supply circuit before installing the
fan and wall control.
9
3.
Securely connect the fan motor
white wire to the supply white
(neutral) wire using wire connec-
tor supplied (Figure 14).
4.
Securely connect the fan motor
black wire to the supply black
(hot) wire using wire connector
supplied (Figure 14).
5.
Cap the blue fan wire with a wire
connector if using the supplied
wall control (Figure 14).
BP7409-1 COPA BREEZE 1/23/13 8:55 PM Page 9
