5
To avoid possible fire or shock, follow
all wiring instructions carefully.
Any electrical work not described in
these instructions should be done or
approved by a licensed electrician.
!
WARNING
If your fan is to replace an existing
ceiling light fixture, turn electricity
off at the main fuse or circuit break-
er box at this time and remove the
existing light fixture.
Turning off wall switch is not suffi-
cient. To avoid possible electrical
shock, be sure electricity is turned off
at the main fuse or circuit breaker box
before wiring. All wiring must be in
accordance with National and Local
codes and the ceiling fan must be prop-
erly grounded as a precaution against
possible electrical shock.
!
WARNING
1.
Remove the fan motor and housing
assembly from the styrofoam pack-
aging and position it so that the
top of the motor is facing you.
2.
Remove the hanger ball from the
downrod by loosening the set-
screw in the hanger ball until the
ball falls freely down the downrod
(Figure 2). Remove the pin from
the downrod, then remove the
hanger ball. Retain the pin and
hanger ball for reinstallation in
step 8.
PIN
HANGER
BALL
SETSCREW
DOWNROD
Figure 2
How to Assemble Your
Ceiling Fan
3.
Separate, untwist and unkink the
three motor leads. Route the
motor leads through the downrod
and seat the downrod in the motor
coupling (Figure 3).
HAIRPIN
CLIP
CLEVIS PIN
SETSCREW (2)
DOWNROD
MOTOR
COUPLING
Figure 3
4.
Align the holes in the downrod
with the holes in the motor
coupling. Install the clevis pin and
secure with the hairpin clip
(Figure 3). (Pin and clip are
supplied in loose parts bag.) The
clevis pin must go through the
holes in the motor coupling and
the holes in the downrod. Push the
straight leg of the hairpin clip
through the hole near the end of
the clevis pin until the curved por-
tion of the hairpin clip snaps
around the clevis pin. The hairpin
clip must be properly installed to
prevent the clevis pin from work-
ing loose. Pull on the downrod to
make sure the clevis pin is proper-
ly installed.
!
WARNING
It is critical that the clevis pin in the
motor coupling is properly installed
and the setscrew securely tightened.
Failure to verify that the pin and
setscrew are properly installed (as
shown in Figure 3) could result in the
fan falling.
BP7409-1 COPA BREEZE 1/23/13 8:55 PM Page 5
