Tommy Bahama CABRILLO COVE, Инструкция по эксплуатации, Страница: 8 / 44

4. How to Assemble Your Ceiling Fan
(Continued)
Locate the hairpin clip 23 from the hardware kit and
install it into the tip of the clevis pin 24 by pushing the
straight leg of the clip through the hole at the tip of the pin.
The curved leg of the hairpin clip must snap around the
outside of the pin for correct installation.
The hairpin clip must be properly installed to prevent the
clevis pin from working loose.
8
Tommy Bahama • 04/2013 email@carrollparts.com • 1-800-875-3545
4.7 4.8
Rotate the downrod 2b or 3 until its bottom mounting
holes are aligned with the mating mounting holes of the
motor coupling e .
Locate the clevis pin 24 from the hardware pack and push
it into the aligned mounting holes.
The motor wires may cause some interference and it may
take several attempts to push the pin through both side of
the downrod.
24
e
2b or 3
23
24
Loosen two motor coupling setscrews d so that they do
not protrude into the interior of the motor coupling e .
Position the downrod 2b or 3 above the motor coupling
and carefully slip it into the coupling until it is fully
inserted.
4.5 4.6
Separate, untwist and unkink the three coiled motor wires
protruding from the top of the motor 4 .
Route all three motor wires into the end of the selected
downrod 2b or 3 and push until they appear at the
opposite end. Grasp the end of the wires and pull the
remaining wire through the downrod.
4
2b or 3
4
e
d d
2b or 3
d