5. How to Remove the Light Kit from the Fan
5.2
Locate and remove the small orange wire connectors 10c
attached to the blue and black wires (labeled "For Light Kit
Connection") and the two white wires (labeled "For Light
Kit Connection"). Retain the wire connectors 10c for
future use.
10c
10c
5.1
Locate the light kit assembly 10 and place it on a padded
work surface. Position it so that the wires are visible.
The light kit consists of two major components:
1. Switch Cover Assembly 10a .
2. Light Fitter Assembly 10b .
10
10a
10b
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse or circuit breaker box before
wiring. All wiring must be in accordance with
National and Local codes and the ceiling fan must be
properly grounded as a precaution against possible
electrical shock.
!
WARNING
This ceiling fan can be installed without the light kit.
If you would like to install your fan without a light kit, please follow the below instructions.
Skip to Section 6 if you wish to install the light kit assembly on your ceiling fan.
If the light kit is already assembled to the fan, and you want to remove it, reverse Section 6 assembly instructions
to uninstall the light kit assembly and then follow Section 5 instructions to disassemble the light fixture from the
switch cover.
13
Tommy Bahama • 04/2013
[email protected] • 1-800-875-3545
5.3
h
i
On the switch cover in the center is a threaded tube, you
will find a hex nut h (1/8-27 NPS) and i lock washer.
Loosen and remove the hex nut h with a 14 mm. end
wrench, and the lockwasher i . Retain both for the next
step.
