Safety and use instructions:
The device is designed to be attached to LFL-CL LED lighting with monochrome
and multicoloured spectrum to regulate its intensity and light mode.
Before you start using it, make sure that the device is complete and no parts
are visibly damaged.
Before connecting or disconnecting the mini receiver, make sure the power
cable of LFL-CL lighting is unplugged from electricity. Connect the device
according to the following scheme.
Caution! Do not exceed the input voltage and output current:
Danger of permanent damage of the device / RF mini receiver.
AC adapter of
LFL-CL
LFL-CL LED lighting
Plug in AC
100-240V
RF mini receiver
Connection scheme:
Remote control functions:
1
2
10,11
3,8,9
4,6
5,7
–
Turn on / Stand by
–
Lighting mode: direct switch
from dynamic mode
– Dimmer adjust:
+increasing / -reducing the
brightness level in 10 steps
– Dimmer adjust: direct switch
to brightness level of 100%,
50%, 25%
– Dynamic mode: switch from
lighting mode and further
switch between 8 different
dynamic modes
– Speed adjust: switch from
lighting mode and further
increasing / -reducing
the speed level in 10 steps
Dynamic modes and speed levels:
Switch on the power supply cable. Remove the protective plastic stripe
from battery and start using the remote control functions.
Switch
When replacing the battery in remote control, use only the indicated type.
The remote control enables to switch
between 8 different dynamic modes such as flashing, pulsing, shimmering etc.
and 10 speed levels for each dynamic mode.
Avoid any contact of the device with water.
If the mini receiver does not respond, loss of communication is likely.
Turn off the main switch of the lighting, the mini receiver remains connected.
Press buttons 5 a 7 (SPEED-/SPEED+) at the same time, then turn on the main
switch on and start using the remote control functions. The action can be
repeated in case of need.
Pairing of remote control and RF wireless mini receiver: