PAGE 14
ONE PASS SCRUBBING
BRUSH DRIVE MACHINES - (SEE BELOW)
1. Turn on machine power switch
"A"
, make sure
the "PAD ASSIST
"
adjustment knob
"B"
is at a
low setting.
2. Lower squeegee by rotating the squeege lift lever
"C"
all the way to the right (vac motor will turn on
automatically.)
3. Lower scrub head to the floor, use the
top half (+) of the brush switch
"D"
.
4. Turn on the solution switch
"E"
.
5. Begin scrubbing by depressing the green control
button
"F"
on the handle bar. Adjust the "PAD
ASSIST"
adjustment knob
"B"
to the desired setting.
6. Once the machine begins to move, check
the down pressure gauge
"G"
. Start scrubbing
at the middle. Do not scrub in the red, or the
circuit breaker will blow.
7. To stop the machine, let go of the green
control button
"F"
.
SCRUB ONLY
BRUSH DRIVE MACHINES - (SEE BELOW)
1. Turn on machine power switch
"A"
, make sure
the
"PAD ASSIST"
adjustment knob
"B"
is at a
low setting.
2. Lower scrub head to the floor, use the
top half of the brush switch
"D"
.
4. Turn on the solution switch
"E"
.
5. Begin scrubbing by depressing the green control
button
"F"
on the handle bar. Adjust the
"PAD
ASSIST"
adjustment knob
"B"
to the desired setting.
6. Once the machine begins to move, check
the down pressure gauge
"G"
. Start scrubbing
at the middle. Do not scrub in the red, or the
circuit breaker will blow.
7. To stop the machine, let go of the green
control button
"F"
.
VACUUM ONLY
BRUSH DRIVE MACHINES - (SEE BELOW)
1. Turn on machine power switch
"A".
2. Lower squeegee by rotating the squeege lift
lever
"C"
all the way to the right (vac motor will
turn on automatically.)
3. Push machine forward over solution.
G
A
E
D
C
F
B
