Tomcat edge 20" stick hd, Руководство по эксплуатации

Страница: 7 / 22

EDGESTICK-OP-EN
- 7 -
MACHINE SETUP
INSTALLING EDGE PADS:
To install or replace a Pad:
NOTICE
Before installing or replacing any Pad, disconnect the
EDGE Scrubber from its power source.
1. Lock handle (A) in the upright position (SEE BELOW) .
2. Tilt machine back until the handle rests on the fl oor
(SEE BELOW) .
3. Remove existing Pad and replace with new Pad -
ensure proper 1/2''overhang on all edges of Grip Face.
4. Press Pad fi rmly into place.
5. Return machine to upright position.
NOTICE
NEVER place aggressive Pads (Maroon Prep, Dominator
HD Strip, etc.) directly onto the Grip Face. Always use
Red or Blue Spacer pad to prevent Grip Face damage.
PRE-CLEANING CHECKLIST:
Read and understand the Safety Messages section on
Pages 3 and 4 before operating the machine.
6. Check and make sure that there is electrical outlets
available for use or large gauge extension cords.
7. Check the condition of the Pads or Brushes.
8. If there is debris on the fl oor area that is about to be
scrubbed - pre-sweep area.
OPERATING - SCRUBBING:
1. Move machine to work location. Never transport or
store the machine without a Pad to protect the grip
face.
2. Check the Pad. If it has become reduced to a
thickness of less than 1 ⁄
2
’’, replace the Pad. Pad will
depend based off of the application needs, contact
your Local Servicing Dealer for correct Pads for your
application.
3. Connect machine cord to power source. When
scrubbing an area, move so that you are moving
away from the power supply. This will help avoid
entanglement with the cord as well as reduce the need
to move do a different power source.
4. Adjust the handlebars to a comfortable position.
Lock the handlebar into position. The best operating
position is at arms length to help with control of
machine and to improve operator comfort. Maintain
the machine fl at on the fl oor for ease of operation.
Raising or lowering the handlebar can cause the
machine to pull to the right or left, and uneven
pressure/wear on the pad surface. A neutral handlebar
position will provide a neutral operation and uniform
contact of the Pad to the fl oor surface.
5. Squeegee the Handlebar trigger with both hands to
start the machine. Release the Handlebar trigger to
stop the machine.
NOTICE
Releasing the Handlebar trigger will immediately stop
the machine.
A
MACHINE OPERATION