PAGE 10
MACHINE SETUP
REPLACING MAIN BROOM
1. TURN THE MACHINE OFF. USE A 9/16 INCH
WRENCH TO REMOVE THE 3/8-16 HCS BOLT IN
THE CENTER OF ARM AND REMOVE THE IDLER
ARM ASSEMBLY.
(SEE FIGURE 10.)
2. THE MAIN BROOM SHOULD SLIDE OUT THE SIDE
OF THE MACHINE EASILY.
(SEE FIGURE 12.)
3. SLIDE THE NEW BROOM IN. WHEN YOU GET THE
BRUSH ON THE DRIVER SPIN IT WITH YOUR HAND
UNTIL YOU FEEL IT CATCH ON THE DRIVER AND THEN
PRESS IT COMPLETELY ON.
(SEE FIGURE 12.)
4. WITH THE MAIN BROOM COMPLETELY INSTALLED,
REPLACE THE IDLER ARM AND THE FASTENERS.
THE ARM SHOULD GO ON EASILY, AND METAL
TO METAL. IF THERE IS ANY GAPS LEFT BEFORE
TIGHTENING, IT HAS NOT BEEN INSTALLED
PROPERLY.
(SEE FIGURE 13.)
NOTE: SELECT THE BROOM FIBER THAT BEST MEETS YOUR CLEANING APPLICATION
CONSULT YOUR LOCAL CEALER FOR ASSISTANCE.
(SEE BRUSH TYPES ON PAGE 4.)
WARNING:
IF THE BROOM IS NOT FULLY ENGAGED
WITH THE DRIVERS, THE BRUSHES WILL
BE DAMAGED. DO NOT FORCE THE
IDLER ARM BACK ON. THIS USUALLY
INDICATES IMPROPER INSTALLATION
(FIGURE 10.)
(FIGURE 12.)
(FIGURE 11.)
(FIGURE 13.)
