S-SERIES
2. To maintain the easy adjustability of the
Resistance system, the threads on the lower end
of the brake rod should be lubricated. First, turn the
Resistance knob clockwise until it stops. Next, look
under the right or left side of the frame and locate
the brake rod, which has two lock nuts on its lower
end. Apply a small amount of synthetic grease
(white lithium grease) to the threads on the brake
rod above the two lock nuts. Then, turn the
resistance knob counter-clockwise until it stops.
ENG
Graphics are the right side
of the Bike (ridding position)
! ONLY CHAIN DRIVE !
3. Chain driven bike
Important:
A loose chain as well as an over-
tightened chain will cause damage to the chain and
drive system.
Checking Chain Tension:
To check
for an over-tightened chain, sit on the saddle, place
your feet on the pedals, and begin pedaling while
feeling for excess vibration. Unusual noises or
vibrations are indications that the chain may be over
tightened or that the flywheel is at an angle
(misaligned). To check for a loose chain, sit on the
saddle, place your feet on the pedals, move the
pedals until the crank arms are horizontal. Next,
push down the emergency brake handle and hold
it. Then, stand on the pedals and rock forward and
backward. There should be no more than 1/8th inch
(2–3 mm) of play in the chain. If there is too much
play in the chain, or if the chain makes a clicking
noise, this indicates that the chain is too loose.
To correct an over-tightened chain:
To adjust the
chain, pull off the right and the left maintenance
covers
(A)
. Loosen the axle nut
(B)
on both ends
of the flywheel axle by two full turns. Loosen the inner
adjustment nut
(D)
facing the flywheel axle nut
on each side of the flywheel. Then, turn both (right
and left sides) of the outer adjustment nuts
(C)
on
the outside of the flywheel bracket ¼ of a turn at a
time (downward on the R side and upward on L side)
until the chain is properly adjusted. Make sure to turn
both adjustment nuts exactly the same amount to
avoid misalignment of the flywheel. Re-check the
amount of play in the chain as described at the be-
ginning of this step. If necessary, readjust the chain.
! ONLY CHAIN DRIVE !
Version 2.1 Copyright by Indoorcycling Group GmbH 2009
|
www.indoorcycling.com
ENG 15
2
3
A
B
C
