TOLSEN TOOLS Force Xpress 79575, Инструкция по эксплуатации

Страница: 6 / 16

6
SETUP AND SPECIFICATIONS
Start/stop of the machine
Multi Nozzle
The trigger gun and lance is affected by a thrust during operation - therefore always hold it firmly with both hands.
IMPORTANT: Point the nozzle at the ground.
Check that the machine is in upright position. NOTE: Do not place the machine in high grass!
Release the trigger lock .
Activate the trigger of the trigger gun and let the water run until all air has escaped from the water hose.
Press the Start/stop switch.
Activate the trigger of the trigger gun.
Always adjust the distance and thus the pressure of the nozzle to the surface, which is to be cleaned.
Do not cover the machine during operation or use it in a room without adequate ventilation!
NOTE: If the machine is left or not used for 5 minutes, it must be switched off on the start/stop switch "O":
Press the start/stop switch "O".
Disconnect the electrical plug from the socket.
Shut off the water supply and activate the trigger of the trigger gun to relieve the machine of pressure.
Lock the trigger gun
When releasing the trigger of the trigger gun, the machine automatically stops. The machine will start again when you re- activate
the trigger gun
The pressure can for the multi nozzle be adjusted by
tuning it. WARNING: Do not do this under operation to
avoid that the hand hits the jet.
After use instructions
The machine should be stored in a frost-free room!
Pump, hose and accessories should always be emptied of water prior to storing as follows:
Stop the machine (press the start/stop switch “O” and detach water hose, high pressure hose and nozzle
Restart the machine and activate the trigger of the trigger gun Let the machine run until no more water runs through the trigger
gun.
Stop the machine, unplug and wind up hose and cable.
Place trigger gun, lance, nozzles and other accessories in the holders of the machine. The hook can be used for storage of the
hose and cord All accessories can be stored in the washer after using.
WARNING: Never start up a frozen machine. Frost damages are not covered by the guarantee!