(10) External SYNC signal input impedance selection method
The external SYNC signal input impedance can be selected using
the switch S3 in the CONTROL board.
At the time of shipment from the factory, this switch will have
been set to the High Impedance position. To change this setting
to 75
Ω
, set the switch S3 as shown in the figure below.
(11) Video output AC coupling/DC coupling selection method
The AC coupling/DC coupling selection can be made using the
switch S1 in the PROCESS board.
This switch will have been set to the AC coupling position at the
time of shipment from the factory. To change this setting to DC
coupling, set S1 as shown in the figure below.
- 9 -
4. CONNECTION
When installing the CS8330B/CS8330BC camera to your system,
you have to connect between equipments.
4-1. Typical connection.
* AC adapter CA130B/140B is an optional accessory, make choice of
the most appropriate power supply system, depending on the
application.
* Typical connection of CS8330B/CS8330BC. There are two
connectors of "VIDEO OUT", and "DC-IN/SYNC" at the rear panel
on the camera.
- 10 -
