I N S T R U C T I O N M A N U A L
07
I N S T R U C T I O N M A N U A L
06
Before your first use
1. Remove any packaging and factory labeling from TObi® Platinum™.
2. Assemble TObi® Platinum™ according to the assembly instructions section,
then fill the Water Tank with water to the max level, then operate TObi®
Platinum™ according to the operation instructions.
Assembly Instructions
I.
Assembling and mounting the Telescopic Pole. (SEE FIG.1)
1. Loosen the three plastic knobs by moving them outwards from the telescopic
pole.
2. Carefully extend the lower, middle and upper part of the pole once the knobs
are loosened.
3. Once all the parts are extended, lock them into place by moving the plastic
knob inwards.
Note:
The Telescopic Pole must be fully extended during operation of TObi®
Platinum™ to ensure a free flow of steam through the Hose.
Note:
Overextending the pole may cause it to break.
4. Loosen the Pole base by turning it counterclockwise.
5. Insert the bottom of the Pole into the Pole base (SEE FIG. 2).
6. Push the Pole down as far as possible.
7. Tighten the Pole base by turning the ridged knob clockwise.
8. Insert the clothes hanger assembly to the top of the pole & press down until it is stable.
Fig. 2
Fig. 3
II.
Attaching the Hose
1. Insert Hose onto the Hose base until the end & turn hose clockwise. (SEE FIG. 3).
2. Hand-tighten only. Do not over-tighten.
3. Hang the Metal Teflon Steam Head on the Metal Teflon Steam Head Holder.
CAUTION:
To prevent steam from causing bodily injury or damage to surfaces,
always hang the Metal Teflon Steam Head on the Metal Teflon Steam Head
Holder when not in use. Do not lay the Hose on the floor as condensation
may occur, causing unwanted water droplets in the steam.
CAUTION:
Pulling on the Hose with excessive force will damage it,
resulting in a steam leak.
III.
Attachments (Upholstery & Lint/Pet Hair Attachment)
1. Turn TObi® Platinum™ to “OFF” position, and wait until
steam no longer emits from the Metal Teflon Steam Head.
CAUTION:
To avoid burns, do not try to install the
attachments while steam is coming from the Metal
Teflon Steam Head.
2. Align the pegs along the back of the attachments with the
holes on the Steam Nozzle.
3. Push as shown in FIGURE 4 until the attachments are firmly in place.
Fig. 4
Fig. 1
