Toa WM-D5200, Инструкция по эксплуатации

Страница: 13 / 24

13
8.3. performing code settings (When encryption Function is oFF)
8.3.1. code setting summary
By presetting the specified code between the wireless microphone and receiver, audio is only
output when a digital signal received from the wireless microphone has the same ID code as the
receiver. Even if another signal is received from an adjacent area, if the code does not match, audio
is not output.
Ten varieties of code can be selected ([0] – [9]) for appropriate use, depending on circumstances.
8.3.2. code settings
Code is factory-preset to "0."
note
Switch OFF the microphone power switch when performing settings. If the power switch is left ON,
the codes will remain unaffected even if the settings are manually changed.
step 1. After removing the battery compartment cover, switch ON
the microphone power switch.
step 2. Confirm that the Encryption indicator is unlit.
If it is lit, switch encryption from ON to OFF, referring to p.
11, "Switching the Encryption function from OFF to ON."
step 3. Switch OFF the power.
step 4. Using the supplied screwdriver, set the code setting switch to
the desired code number.
step 5. Reinstall and securely tighten the battery compartment
cover, as it was before.
This puts the code into the set state.
step 6. Set the same code number for the receiver, as well.
For the setting method, see the instruction manual enclosed
with the receiver.
1
2
4
Encryption indicator
Unlit
Code setting switch