Toa WM-D5200, Инструкция по эксплуатации

Страница: 11 / 24

11
8.2.2. performing encryption settings
[switching the encryption function from oFF to on]
See also the instruction manual enclosed with the WT-D5800 receiver.
step 1. Enable the receiver's encryption function.
step 2. With the battery compartment cover removed, switch ON the
microphone power switch and confirm that the Encryption indicator
is unlit.
If the indicator is lit, switch encryption from ON to OFF (see p. 12).
step 3. Switch OFF the microphone power switch.
step 4. Switch ON the microphone power switch while holding down the
microphone's Encryption setting switch (continue holding until step
6).
Confirm that the microphone's Encryption indicator is flashing.
An ID number is transmitted while the microphone's Encryption
setting switch is held down.
step 5. Perform pairing setting at the receiver.
The receiver waits for the microphone’s transmitted ID number for
as long as the Set key is held down. The "RECEIVING" indication
is displayed on the receiver's LCD screen until the ID number is
correctly received.
step 6. After confirming that the LCD display has switched to the "SUCCESS"
indication, release both the microphone's Encryption setting switch
and the receiver's Set key.
step 7. Confirm that the microphone's Encryption indicator is lit.
The encryption setting is now ON.
notes
• Do not switch OFF the power to the microphone or receiver during setting.
• Hold down the microphone's Encryption setting switch and the receiver's Set key until the
"SUCCESS" indication appears on the receiver's LCD screen.
If the microphone's Encryption setting switch or the receiver's Set key is released while the
"RECEIVING" indication is displayed on the receiver's screen, the receiver will not have correctly
received the new ID number, leaving the ID number unchanged from the previous value. To match
the receiver ID number with the microphone ID number, switch OFF the microphone's encryption
setting, then repeat steps 1 – 7 above.
tips
• The ID number is updated when the encryption is switched from OFF to ON again. (The encryption
ON/OFF status and ID number are retained even if the power switch is switched OFF.)
• Settings can be performed regardless of whether the microphone or receiver Encryption setting
switch was depressed first.
• The receiver does not output audio during ID number setting, even if it receives a radio signal from
the microphone.
Unlit
Flashing
Lit