3.5. terminal station Connection
The N-8000EX/8010EX comes with a mini-clamp
connector of Type A or Type B as shown below.
Both types of connectors differ in their shapes and
connection methods.
[shape of connectors (side views)]
[Cable connection procedures]
step 1. Connect the cables to the mini-clamp connector.
1-1. Cut off two-cable ends in equal length, and insert
them securely to a cover section of the mini-
clamp connector.
note
Insert the cable without stripping the cable jacket.
Type A
Type B
(Type A connector) (Type B connector)
Cover (Transparent)
Cable
1-2. With pliers, lightly pinch the mini-clamp cover,
and after ensuring that the cable is securely
inserted, firmly squeeze on the cover.
note
Squeeze on the mini-clamp cover until it is
correctly locked.
step 2. Insert the wired connector (plug) into the
exchange's connector (socket) until it locks into
place.
N-8000EX/8010EX Rear panel
1-3. Cut off the cable sticking out of the connector
case with nippers. (Type B connector only.)
Raise the cable sticking out as shown below, then
cut it off so that it comes out as less as possible
from the connector case.
3.6. terminal Plug Connection
step 1. Strip a cable jacket of approx. 5 mm from the
cable end.
5 mm
note
Do not solder plate on exposed inner cables
when using a stranded wire.
step 2. Loosen the terminal screws and insert the cables.
step 3. Tighten the terminal screws securely.
notes
• Tug lightly on the cable to be sure that it does
not pull free. If the cable pulls free, loosen the
terminal screw again and reconnect from step
2.
• To avoid stripping the screws, use the
screwdriver appropriate to the screws tightened
into the terminal plug.
step 4. Insert the wired terminal plug into the pin header
on the N-8033MS's PC board.
Removable terminal plug
(accessory)
N-8033MS's
PC board
Pin header
Cable
3
2
4
Tighten
1 2
133-41-080-60
URL: http://www.toa.jp/
traceability information for europe (eMC directive 2004/108/eC)
Manufacturer:
TOA Corporation
7-2-1, Minatojima-Nakamachi, Chuo-ku, Kobe, Hyogo, Japan
Authorized representative:
TOA Electronics Europe GmbH
Suederstrasse 282, 20537 Hamburg, Germany
Warning
This is a class A product. In a domestic environment this product may cause radio interference in which case the user
may be required to take adequate measures.
