23
Item
Contents
(6) Offset Volume
The offset volume can be set to equalize the sound output of individual patterns
or change the output level for each pattern.
Changes to the offset volume settings are enabled from the next broadcast
after such changes are saved.
Setting range: −20 to +20 dB
Initial setting: 0 dB
(7) Control-out
(Control output button)
Connected external equipment can be controlled by transmitting a signal from
the control output during broadcasts of internal sound source files.
If the checkbox at right is marked, the external control output turns ON when
the unit begins broadcasting internal sound source files, and turns OFF when
the broadcast is stopped.
(8) PLAY button
Click to start the test broadcast of a broadcast pattern. (Refer to the following
section, Performing Broadcast Tests.)
(9) STOP button
Click to stop the test broadcast of the broadcast pattern.
(Refer to the following section, Performing Broadcast Tests.)
(10) SAVE button
Click to save the settings and changes. (See
"Saving Settings & Changes" on
.)
12.2. Performing Broadcast Tests
Follow the procedure below to conduct broadcast tests for selected broadcast patterns:
Note
Neither the PLAY nor STOP buttons can be used if the set contents have not yet been saved.
Step 1. Click and select the broadcast pattern to be tested.
Step 2. Click on the PLAY button.
A test broadcast of the selected broadcast pattern will begin.
Step 3. Click on the STOP button to stop the test.
The test broadcast stops.
1
2 3
